Home > News > How About Fiber Optic Laser Cutter For Metal? Look At These To Know

NEWS

How About Fiber Optic Laser Cutter For Metal? Look At These To Know
2019-09-18


There are many ways to cut metal: in addition to shearing machines, combined punching and shearing machines, slitting machines, water cutting machines, etc., as well as thermal cutting equipment including plasma cutting machines and fiber optic laser cutters. Among them, the fiber optic laser cutter adopts the numerical control system, which can cut and engrave complex patterns on the thin plate, and has excellent precision. It can also be applied to metal thick plate cutting, and has been widely used in the field of sheet metal processing!



Cutting stainless steel

Stainless steel is used in a wide range of applications, such as kitchen equipment, general tensile materials, gas stoves, refrigerators, electrical appliances, washing machines, building materials, regrind, elevators, interior and exterior decorative materials, chemical equipment, heat exchangers, boilers, etc. You can see the figure of stainless steel!

Stainless steel laser cutting, not only cost less than the traditional wire cutting, but also twice the speed of wire cutting, can achieve high-volume production, is a fast and effective processing method!

Perfect Laser fiber optic laser cutter cuts 3mm and 6mm stainless steel


Cutting carbon steel

Fiber optic laser cutter is widely used in carbon steel cutting. The advantage of fiber optic laser cutter is that it can cut any design pattern on the board, with high speed and high precision. It can be formed in one time without subsequent processing. And the fiber optic laser cutter cuts carbon steel without casting, saving cost, visually discharging, tightly fitting and saving materials.


Cutting non-ferrous metals

Fiber optic laser cutter can also be used to cut non-ferrous metals (copper and brass). Both materials have high reflectivity and very good thermal conductivity. Brass having a thickness of 1 mm or less can be cut by nitrogen laser cutting; copper having a thickness of 2 mm or less can be cut, and oxygen for laser cutting processing must be used. It should be noted that when cutting copper and brass, a "reflective absorption" device is required on the system.


Perfect Laser fiber optic laser cutter cuts 3mm brass

Perfect Laser numerical control fiber optic laser cutter meets a variety of metal cutting needs, with a variety of power configurations, it is understood that this equipment uses a high-quality cutting process library, product stability, long life, practicality, excellent dynamic response. The cutting width of up to 6m*2.55m meets the horizontal placement of multiple 1.25*2.5m plates, greatly improving the cutting efficiency.